In vivo toxicological assessment of diquat dibromide: cytotoxic, genotoxic, and biochemical approach

Diquat dibromide is a comprehensive herbicide commonly used in the cultivation of cotton, soybeans, and other crops to combat unwanted weeds. In this study, the half-maximal effective concentration (EC₅₀) value of diquat dibromide was determined 60 mg/L in the Allium root growth inhibition test. ½ × EC₅₀ (30 mg/L), EC₅₀ (60 mg/L), and 2 × EC₅₀ (120 mg/L) concentrations of diquat dibromide were applied to Allium cepa L. bulbs for 72 h to investigate the dose-dependent toxic effects. To determine the toxic effects cytogenetic, biochemical and physiological parameters were used. Physiological effects were investigated by determination of the percentage of rooting, relative injury rate, root length, and weight gain. Genetic effects were evaluated by the frequency of chromosomal abnormalities (CAs), micronucleus (MN) formation, mitotic index (MI) rate, and comet assay. Biochemical parameters were evaluated with antioxidant Enzyme activities and lipid peroxidation by determining malondialdehyde (MDA) level, superoxide dismutase (SOD) activity, catalase (CAT) activity, and glutathione (GSH) level. Also, chlorophyll pigment contents (a, b, and total) in green leaves were calculated to elucidate the effect of diquat dibromide on Plants and the biosphere. The findings show that increasing doses of diquat dibromide caused a decrease in all physiological parameters and MI ratio, promoting MN and CAs and tail DNA formation in genetic parameters. It was determined by the increases in MDA level, SOD, and CAT activities and decreases in GSH levels that diquat dibromide administration caused oxidative stress depending on the dose. Also, chlorophyll pigment levels (a, b, and total) measured in leaf tissues decreased with the application dose. Considering that the toxic effects caused by diquat dibromide and that organisms other than unwanted Plants will be exposed during the application, its use should be abandoned and biocontrol methods should be used instead. In cases where use is compulsory, doses that will not harm the environment and organisms should be determined and used.