Dimethyl trisulfide
Based on 1 Customer Validation
Dimethyl trisulfide is a cyanide scavenger. Dimethyl trisulfide can be isolated from garlic, onions, broccoli and similar plants. Dimethyl trisulfide converts cyanide into thiocyanate. Dimethyl trisulfide is used by saprophagous insects to locate breeding sites (decaying organic matter), and is also used by deceptive flowers in brood sites to attract such insects. Dimethyl trisulfide induces electrophysiological responses in houseflies.
商品は「研究用試薬」です。人や動物の医療用・臨床診断用・食品用の製品ではありません。
研究用途以外に使用した場合、当社は一切の責任を負いかねます。
- 純度: 99.71%
- CAS 番号: 3658-80-8
- 分子式: C2H6S3
- 分子量:126.26
-
保管条件:Pure form -20°C, 3 years , 4°C, 2 years ; In solvent -80°C, 6 months , -20°C, 1 month
To place orders, for customer services and technical support, please contact: MedChemExpress USA
Tel: 609-228-6898 E-mail: [email protected] [email protected]
-
生物活性
-
化学情報
-
溶剤 & 溶解度
- 純度とドキュメンテーション
- 参考文献
-
Help & FAQs
生物活性
Dimethyl trisulfide (10-6-10-1 v/v) induces a significant dose-dependent electrophysiological response in the antennae of female Lucilia sericata[1].
Dimethyl trisulfide is observed to convert cyanide to thiocyanate with greater than 40 times higher efficacy than does thiosulfate in experiments carried out in vitro in the presence of the sulfurtransferase rhodanese (Rh) and at the
experimental pH of 7.4[2].
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Animal Model:CD-1 (male, 18-28 g)[2]
-
Dosage:100 mg/kg
-
Administration:i.m.; single dose (administered 30 seconds post-cyanide exposure)
-
Result:Achieved an antidotal potency ratio (APR) of 3.3.
Increased the LD50 of potassium cyanide from 10.9 mg/kg (95% CI 8.6-13.9) to 36.0 mg/kg (95% CI 28.7-45.1).
化学情報
-
CAS 番号 3658-80-8
-
性状 Liquid (Density: 1.202 g/cm3)
-
分子量 126.26
-
分子式 C2H6S3
-
Color Colorless to light yellow
-
SMILES
CSSSC
-
別名
ジメチルトリスルフィド
-
Structure Classification
-
Initial Source
marine Rhodobacteraceae species
-
輸送条件
Room temperature in continental US; may vary elsewhere.
-
保管条件
Pure form -20°C 3 years 4°C 2 years In solvent -80°C 6 months -20°C 1 month
溶剤 & 溶解度
DMSO : 100 mg/mL (792.02 mM; Need ultrasonic; Hygroscopic DMSO has a significant impact on the solubility of product, please use newly opened DMSO)
H2O : 1 mg/mL (7.92 mM; Need ultrasonic)
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month. When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month. When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
濃度 (開始) × 体積 (開始) = 濃度 (終了) × 体積 (終了)
Select the appropriate dissolution method based on your experimental animal and administration route.
- For the following dissolution methods, please ensure to first prepare a clear stock solution using an In Vitro approach and then sequentially add co-solvents:
- To ensure reliable experimental results, the clarified stock solution can be appropriately stored based on storage conditions. As for the working solution for In Vivo experiments, it is recommended to prepare freshly and use it on the same day.
- The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.
Add each solvent one by one: 10% DMSO 40% PEG300 5% Tween-80 45% Saline
Solubility: ≥ 2.5 mg/mL (19.80 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 400 μL PEG300, and mix evenly; then add 50 μL Tween-80 and mix evenly; then add 450 μL Saline to adjust the volume to 1 mL.
Preparation of Saline: Dissolve 0.9 g sodium chloride in ddH₂O and dilute to 100 mL to obtain a clear Saline solution.
Add each solvent one by one: 10% DMSO 90% (20% SBE-β-CD in Saline)
Solubility: ≥ 2.5 mg/mL (19.80 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 900 μL 20% SBE-β-CD in Saline, and mix evenly.
Preparation of 20% SBE-β-CD in Saline (4°C, storage for one week): 2 g SBE-β-CD powder is dissolved in 10 mL Saline, completely dissolve until clear.
For the following dissolution methods, please prepare the working solution directly:
It is recommended to prepare fresh solutions and use them promptly within a short period of time.
The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.
Add each solvent one by one: PBS
Solubility: 100 mg/mL (792.02 mM); Clear solution; Need ultrasonic
Please enter the basic information of animal experiments:
-
-
-
-
Recommended: Prepare an additional quantity of animals to account for potential losses during experiments.
Please enter your animal formula composition:
-
%DMSO +
Recommended: Keep the proportion of DMSO in working solution below 2% if your animal is weak.
-
%+
-
+%Tween-80 + +
-
%Saline +
The co-solvents required include: DMSO, . All of co-solvents are available by MedChemExpress (MCE). , Tween 80. All of co-solvents are available by MedChemExpress (MCE).
Working solution concentration: 0.22 mg/mL
Method for preparing stock solution: mg drug dissolved in μL DMSO. Stock solution concentration: mg/mL.
1. Take μL DMSO stock solution;
2. Add μL .
μL , mix evenly;
3. Then add μL Tween 80, mix evenly;
4. Then add μL
Please ensure that the stock solution in the first step is dissolved to a clear state, and add co-solvents in sequence. You can use ultrasonic heating (ultrasonic cleaner, recommended frequency 20-40 kHz), vortexing, etc. to assist dissolution.
純度とドキュメンテーション
-
データシート (271 KB)
-
SDS (544 KB)
- English - EN (544 KB)
- Français - FR (544 KB)
- Deutsch - DE (544 KB)
- Norwegian - NO (544 KB)
- Español - ES (544 KB)
- Swedish - SV (544 KB)
- Italian - IT (544 KB)
- Korean - KR (544 KB)
- Portuguese - PT (544 KB)
-
取扱説明書 (2659 KB)
参考文献
Complete Stock Solution Preparation Table
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month. When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
| Optional Solvent | Concentration Solvent Mass | 1 mg | 5 mg | 10 mg | 25 mg |
|---|---|---|---|---|---|
| H2O / DMSO | 1 mM | 7.9202 mL | 39.6008 mL | 79.2016 mL | 198.0041 mL |
| 5 mM | 1.5840 mL | 7.9202 mL | 15.8403 mL | 39.6008 mL | |
| DMSO | 10 mM | 0.7920 mL | 3.9601 mL | 7.9202 mL | 19.8004 mL |
| 15 mM | 0.5280 mL | 2.6401 mL | 5.2801 mL | 13.2003 mL | |
| 20 mM | 0.3960 mL | 1.9800 mL | 3.9601 mL | 9.9002 mL | |
| 25 mM | 0.3168 mL | 1.5840 mL | 3.1681 mL | 7.9202 mL | |
| 30 mM | 0.2640 mL | 1.3200 mL | 2.6401 mL | 6.6001 mL | |
| 40 mM | 0.1980 mL | 0.9900 mL | 1.9800 mL | 4.9501 mL | |
| 50 mM | 0.1584 mL | 0.7920 mL | 1.5840 mL | 3.9601 mL | |
| 60 mM | 0.1320 mL | 0.6600 mL | 1.3200 mL | 3.3001 mL | |
| 80 mM | 0.0990 mL | 0.4950 mL | 0.9900 mL | 2.4751 mL | |
| 100 mM | 0.0792 mL | 0.3960 mL | 0.7920 mL | 1.9800 mL |
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
Dimethyl trisulfide 関連分類
HY-128454 関連分類
Powered by Bioz