STB-2
STB-2 is a fluorescent dye for near-infrared window II (NIR-II) fluorescence angiography. STB-2 achieves high-brightness NIR-II fluorescence by restricting the twisted intramolecular charge transfer state. STB-2, when modified with ApoE to form nanoparticles, can cross the blood-brain barrier and accumulate in gliomas (Ex/Em = 808/1020 nm). STB-2 is used in studies related to NIR-II fluorescence and single-/two-photon cerebrovascular imaging of gliomas.
商品は「研究用試薬」です。人や動物の医療用・臨床診断用・食品用の製品ではありません。
研究用途以外に使用した場合、当社は一切の責任を負いかねます。
- 分子式: C92H76N6S4
- 分子量:1393.89
-
保管条件:
Please store the product under the recommended conditions in the Certificate of Analysis.
生物活性
製品説明
体外実験
Operating Instructions
(The following is a recommended experimental protocol for guidance only, and needs to be adjusted according to your specific requirements).
1. Stock Solution Preparation
1.1 Solvent: Tetrahydrofuran (THF).
1.2 Concentration Recommendation: It is recommended to prepare a high-concentration stock solution of 1-10 mM.
2. Working Solution Preparation
2.1 Diluent: Serum-free medium or PBS is usually used. Proteins and esterases in serum may interfere with staining results or cause dye hydrolysis.
2.2 Working Concentration: 50 μg/mL.
2.3 Notes: The working solution concentration can be adjusted as needed; prepare and use it immediately.
3. Staining Procedure
3.1 Sample Type[1]:
3.1.1 Adherent cells: GL261 glioma cells.
3.2 Incubation Conditions: Incubate cells with 50 μg/mL STB-2@ApoE NPs for up to 8 h.
3.3 Washing Step: No washing step is specified.
4. Control Setup
4.1 Set up only when clearly mentioned in the literature; otherwise, this entire section can be omitted.
4.2 Set up negative controls, including PBS, PBS combined with 808 nm laser irradiation, STB-2 NPs without laser irradiation, and STB-2@ApoE NPs without laser irradiation.
4.3 Positive controls are used to verify the experimental system; blank controls are used to eliminate fluorescent interference from reagents.
5. Detection and Analysis
5.1 Instruments:
5.1.1 NIR-II fluorescence imaging system with an excitation wavelength of 808 nm, using long-pass filters (900 nm, 1000 nm, 1300 nm, 1400 nm, 1500 nm) to detect emitted light.
5.1.2 Two-photon fluorescence microscope with an excitation wavelength of 1700 nm, used for detecting NIR-II fluorescence.
5.1.3 Fluorescence microscope, used for intracellular ROS detection, with excitation of DCFH-DA (green fluorescence) and DAPI (blue fluorescence).
5.1.4 Flow cytometer, used for Annexin V-FITC/PI staining analysis.
5.2 Result Analysis:
5.2.1 Changes in fluorescence intensity: The enhancement of DCFH-DA green fluorescence indicates that 808 nm laser irradiation can induce ROS generation. After administration of STB-2@ApoE NPs, the NIR-II fluorescence intensity in the brain tumor region increases, reaching a peak at 12 h post-injection.
5.2.2 Fluorescence localization: STB-2@ApoE NPs accumulate in GL261 cells and orthotopic gliomas. The NIR-II fluorescence colocalizes with the bioluminescent signal produced by luciferase-labeled GL261 cells.
5.2.3 Changes in fluorescence color: DCFH-DA emits green fluorescence (ROS), DAPI emits blue fluorescence (cell nucleus), calcein-AM emits green fluorescence (live cells), PI emits red fluorescence (dead cells), and STB-2 NPs/STB-2@ApoE NPs emit NIR-II fluorescence (1000-1700 nm).
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
体内実験
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
化学情報
-
分子量 1393.89
-
分子式 C92H76N6S4
-
SMILES
CCC(CCCC)CC1=C(SC(C2=CC(C3(C4=CC=CC=C4C5=C3C=CC=C5)C6=CC=CC=C6N7C8=CC=CC=C8)=C7C=C2)=C1)C9=C(N=S=N%10)C%10=C(C%11=C(CC(CC)CCCC)C=C(C%12=CC=C(N(C%13=CC=CC=C%13)C%14=CC=CC=C%14C%15%16C%17=CC=CC=C%17C%18=C%16C=CC=C%18)C%15=C%12)S%11)C%19=NSN=C%199
-
輸送条件
Room temperature in continental US; may vary elsewhere.
-
保管条件
Please store the product under the recommended conditions in the Certificate of Analysis.
純度とドキュメンテーション
参考文献
Calculators
濃度 (開始) × 体積 (開始) = 濃度 (終了) × 体積 (終了)