4-Hydroxyindole
Based on 1 Customer Validation
4-Hydroxyindole is a type of hydroxyindole in which the 1H-indole at position 4 is substituted by a hydroxyl group. 4-Hydroxyindole serves as an important raw material or intermediate in the synthesis of pharmaceutical products and industrial polymers. 4-Hydroxyindole inhibits amyloid fibrillization and induces liver function impairment, thyroid abnormalities, and blood glucose fluctuations in mice. 4-Hydroxyindole holds potential for research in neurodegenerative diseases and metabolic disorders.
Nos produits utilisent uniquement pour la recherche. Nous ne vendons pas aux patients.
- Pureté: 98.06%
- CAS No.: 2380-94-1
- Formule: C8H7NO
- Masse moléculaire:133.15
-
Stockage:
4°C, protect from light, stored under nitrogen
* In solvent : -80°C, 6 months; -20°C, 1 month (protect from light, stored under nitrogen)
To place orders, for customer services and technical support, please contact: MedChemExpress USA
Tel: 609-228-6898 E-mail: [email protected] [email protected]
-
Activité biologique
-
Chemical Information
-
Solvant et solubilité
- Pureté et documentation
- Références
-
Help & FAQs
Activité biologique
4-Hydroxyindole (0–200 μM, 24 h) inhibits amyloid β (Aβ1-42, 5 μM) fibrillization in a dose-dependent manner, with an IC50 of approximately 85 μM[2]. Kinetic studies shows that 4-Hydroxyindole (5–50 μM, 14 days) inhibits amyloid β aggregation during the elongation phase. Amyloid fibrillization consists of three phases: nucleation (lag phase), elongation phase, and equilibrium phase. At 5 μM, Aβ1-40 fibrillization was inhibited by approximately 60%, while at 25 μM and 50 μM, fibrillization was almost completely suppressed[2]. 4-Hydroxyindole (5–50 μM) dose-dependently blocks amyloid β-induced toxicity in PC12 cells[1].
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Cell Line:PC12 Cells
-
Concentration:5, 25, 50 μM
-
Incubation Time:24 h
-
Result:Dose-dependently protected PC12 cells from Aβ1-40 and Aβ1-42 toxicity. The minimum concentration of 4-Hydroxyindole required to significantly inhibit Aβ1-40 was 2.5 μM, while the toxic effects of both Aβ1-40 and Aβ1-42 were completely blocked at 50 μM 4-Hydroxyindole.
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Animal Model:ICR Albino mice, 25-30 g
-
Dosage:620 mg/kg (4-Hydroxyindole), 320 mg/kg (Oxidation product of 4-Hydroxyindole)
-
Administration:Intracranial injection, Single dose
-
Result:In mice, the LD50 was 620 mg/kg (intracranial injection), showing lower toxicity than its oxidation product (LD50 was 320 mg/kg). Oxidation product of 4-Hydroxyindole induced behavioral abnormalities in mice and reduced blood glucose, cholesterol, and blood urea nitrogen (BUN) levels while increasing liver function enzymes (ALT, AST) and alkaline phosphatase (ALP) levels.
Chemical Information
-
CAS No. 2380-94-1
-
Appearance Solid
-
Masse moléculaire 133.15
-
Formule C8H7NO
-
Color Brown to breen
-
SMILES
OC1=CC=CC2=C1C=CN2
-
Livraison
Room temperature in continental US; may vary elsewhere.
-
Stockage
4°C, protect from light, stored under nitrogen
* In solvent : -80°C, 6 months; -20°C, 1 month (protect from light, stored under nitrogen)
Solvant et solubilité
DMSO : 15.71 mg/mL (117.99 mM; Need ultrasonic; Hygroscopic DMSO has a significant impact on the solubility of product, please use newly opened DMSO)
H2O : 1.43 mg/mL (10.74 mM; Need ultrasonic)
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (protect from light, stored under nitrogen). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (protect from light, stored under nitrogen). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
Concentration (start) × Volume (start) = Concentration (final) × Volume (final)
Select the appropriate dissolution method based on your experimental animal and administration route.
- For the following dissolution methods, please ensure to first prepare a clear stock solution using an In Vitro approach and then sequentially add co-solvents:
- To ensure reliable experimental results, the clarified stock solution can be appropriately stored based on storage conditions. As for the working solution for In Vivo experiments, it is recommended to prepare freshly and use it on the same day.
- The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.
Add each solvent one by one: 10% DMSO 40% PEG300 5% Tween-80 45% Saline
Solubility: ≥ 1.57 mg/mL (11.79 mM); Clear solution
This protocol yields a clear solution of ≥ 1.57 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (15.7 mg/mL) to 400 μL PEG300, and mix evenly; then add 50 μL Tween-80 and mix evenly; then add 450 μL Saline to adjust the volume to 1 mL.
Preparation of Saline: Dissolve 0.9 g sodium chloride in ddH₂O and dilute to 100 mL to obtain a clear Saline solution.
Add each solvent one by one: 10% DMSO 90% (20% SBE-β-CD in Saline)
Solubility: ≥ 1.57 mg/mL (11.79 mM); Clear solution
This protocol yields a clear solution of ≥ 1.57 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (15.7 mg/mL) to 900 μL 20% SBE-β-CD in Saline, and mix evenly.
Preparation of 20% SBE-β-CD in Saline (4°C, storage for one week): 2 g SBE-β-CD powder is dissolved in 10 mL Saline, completely dissolve until clear.
Please enter the basic information of animal experiments:
-
-
-
-
Recommended: Prepare an additional quantity of animals to account for potential losses during experiments.
Please enter your animal formula composition:
-
%DMSO +
Recommended: Keep the proportion of DMSO in working solution below 2% if your animal is weak.
-
%+
-
+%Tween-80 + +
-
%Saline +
The co-solvents required include: DMSO, . All of co-solvents are available by MedChemExpress (MCE). , Tween 80. All of co-solvents are available by MedChemExpress (MCE).
Working solution concentration: 0.22 mg/mL
Method for preparing stock solution: mg drug dissolved in μL DMSO. Stock solution concentration: mg/mL. * In solvent : -80°C, 6 months; -20°C, 1 month (protect from light, stored under nitrogen)
1. Take μL DMSO stock solution;
2. Add μL .
μL , mix evenly;
3. Then add μL Tween 80, mix evenly;
4. Then add μL
Please ensure that the stock solution in the first step is dissolved to a clear state, and add co-solvents in sequence. You can use ultrasonic heating (ultrasonic cleaner, recommended frequency 20-40 kHz), vortexing, etc. to assist dissolution.
Pureté et documentation
-
Fiche technique (280 KB)
-
SDS (393 KB)
- English - EN (393 KB)
- Français - FR (393 KB)
- Deutsch - DE (393 KB)
- Norwegian - NO (393 KB)
- Español - ES (393 KB)
- Swedish - SV (393 KB)
- Italian - IT (393 KB)
- Korean - KR (393 KB)
- Portuguese - PT (393 KB)
-
Instruction de manipulation (2659 KB)
Références
[1]. Nenad Manevski, et al. Glucuronidation of psilocin and 4-hydroxyindole by the human UDP-glucuronosyltransferases. Drug Metab Dispos. 2010 Mar;38(3):386-95. [Content Brief]
[2]. Cohen T, et al. Inhibition of amyloid fibril formation and cytotoxicity by hydroxyindole derivatives. Biochemistry. 2006 Apr 18;45(15):4727-35. [Content Brief]
Complete Stock Solution Preparation Table
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (protect from light, stored under nitrogen). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
| Optional Solvent | Concentration Solvent Mass | 1 mg | 5 mg | 10 mg | 25 mg |
|---|---|---|---|---|---|
| H2O / DMSO | 1 mM | 7.5103 mL | 37.5516 mL | 75.1033 mL | 187.7582 mL |
| 5 mM | 1.5021 mL | 7.5103 mL | 15.0207 mL | 37.5516 mL | |
| 10 mM | 0.7510 mL | 3.7552 mL | 7.5103 mL | 18.7758 mL | |
| DMSO | 15 mM | 0.5007 mL | 2.5034 mL | 5.0069 mL | 12.5172 mL |
| 20 mM | 0.3755 mL | 1.8776 mL | 3.7552 mL | 9.3879 mL | |
| 25 mM | 0.3004 mL | 1.5021 mL | 3.0041 mL | 7.5103 mL | |
| 30 mM | 0.2503 mL | 1.2517 mL | 2.5034 mL | 6.2586 mL | |
| 40 mM | 0.1878 mL | 0.9388 mL | 1.8776 mL | 4.6940 mL | |
| 50 mM | 0.1502 mL | 0.7510 mL | 1.5021 mL | 3.7552 mL | |
| 60 mM | 0.1252 mL | 0.6259 mL | 1.2517 mL | 3.1293 mL | |
| 80 mM | 0.0939 mL | 0.4694 mL | 0.9388 mL | 2.3470 mL | |
| 100 mM | 0.0751 mL | 0.3755 mL | 0.7510 mL | 1.8776 mL |
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
4-Hydroxyindole Related Classifications
HY-34596 Related Classifications
Powered by Bioz