Yoda2
Based on 1 Customer Validation
Yoda2 (KC289), the potassium salt of Yoda1 (HY-18723), is a PIEZO1 agonist with an EC50 of 150 nM. Yoda2 evokes Ca2+ elevation and NO-dependent relaxation. Yoda2 induces relaxation in mouse arterial and cavernous tissues. Yoda2 inhibits glucocorticoid-induced osteoclast formation and bone resorptive activity, reverses glucocorticoid-induced bone density loss and architectural deterioration, and does not induce medication-related osteonecrosis of the jaw in mice. Yoda2 can be used for the researches of hypertension and osteoporosis.
연구목적의 판매만을 진행합니다. 환자를 대상으로 한 판매는 하지 않습니다.
- Purity : 99.57%
- CAS No.: 3081450-95-2
- 화학식: C16H9Cl2KN2O2S2
- 분자량:435.39
-
보관:
4°C, sealed storage, away from moisture and light
* In solvent : -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture and light)
To place orders, for customer services and technical support, please contact: MedChemExpress USA
Tel: 609-228-6898 E-mail: [email protected] [email protected]
-
Biological Activity
-
Chemical Information
-
용액&용해도
- Protocol
- 순도&문서
- References
-
Help & FAQs
All Calcium Channel Isoforms
More
Biological Activity
제품 설명
IC50 & Target
[1]|
PIEZO1 150 nM (EC50) |
In Vitro
Yoda2 (5 µM; 7 days) significantly inhibits Dexamethasone (HY-14648)-induced osteoclast formation and bone resorptive activity in mouse bone marrow-derived mononuclear cells[2].
Yoda2 (0.01-30 μM) acts as a potent agonist of endogenous human PIEZO1 in HUVECs, with an EC50 of 0.15 μM and producing more consistent concentration-dependent intracellular calcium elevations than Yoda1 (HY-18723)[3].
Yoda2 (5 μM) demonstrates high selectivity for PIEZO1 over a panel of 30 other membrane proteins, with only modest binding to adenosine A2a and prostanoid EP4 receptors at 5 μM[3].
Yoda2 can cause concentration-dependent and NO-dependent relaxation in mouse portal vein (EC50 = 1.14 μM)[3].
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
In Vivo
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Animal Model:C57BL/6 wild-type (WT) (3-week-old male); Piezo1flox/flox (3-week-old male); LysM-cre/Piezo1flox/flox (Piezo1LysMD) (3-week-old male)[2]
-
Dosage:0.4 mg/kg
-
Administration:s.c.; twice weekly
-
Result:Reversed significant reductions in bone mineral density and deterioration of bone architecture caused by dexamethasone in WT mice.
Preserved protective effects in Piezo1flox/flox mice but showed no protective effects in Piezo1LysMD mice.
Did not induce medication-related osteonecrosis of the jaw following tooth extraction.
Chemical Information
-
CAS No. 3081450-95-2
-
Appearance Solid
-
분자량 435.39
-
화학식 C16H9Cl2KN2O2S2
-
Color White to off-white
-
SMILES
O=C(O[K])C1=CC=C(C2=NN=C(SCC3=C(Cl)C=CC=C3Cl)S2)C=C1
-
Synonyms
KC289
-
선적
Room temperature in continental US; may vary elsewhere.
-
보관
4°C, sealed storage, away from moisture and light
* In solvent : -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture and light)
용액&용해도
In Vitro:
DMSO : 50 mg/mL (114.84 mM; Need ultrasonic; Hygroscopic DMSO has a significant impact on the solubility of product, please use newly opened DMSO)
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture and light). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture and light). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
Concentration (start) × Volume (start) = Concentration (final) × Volume (final)
In Vivo:
Select the appropriate dissolution method based on your experimental animal and administration route.
- For the following dissolution methods, please ensure to first prepare a clear stock solution using an In Vitro approach and then sequentially add co-solvents:
- To ensure reliable experimental results, the clarified stock solution can be appropriately stored based on storage conditions. As for the working solution for In Vivo experiments, it is recommended to prepare freshly and use it on the same day.
- The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.
In Vivo Dissolution Calculator
Please enter the basic information of animal experiments:
-
-
-
-
Recommended: Prepare an additional quantity of animals to account for potential losses during experiments.
Please enter your animal formula composition:
-
%DMSO +
Recommended: Keep the proportion of DMSO in working solution below 2% if your animal is weak.
-
%+
-
+%Tween-80 + +
-
%Saline +
The co-solvents required include: DMSO, . All of co-solvents are available by MedChemExpress (MCE). , Tween 80. All of co-solvents are available by MedChemExpress (MCE).
Working solution concentration: 0.22 mg/mL
Method for preparing stock solution: mg drug dissolved in μL DMSO. Stock solution concentration: mg/mL. * In solvent : -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture and light)
1. Take μL DMSO stock solution;
2. Add μL .
μL , mix evenly;
3. Then add μL Tween 80, mix evenly;
4. Then add μL
Please ensure that the stock solution in the first step is dissolved to a clear state, and add co-solvents in sequence. You can use ultrasonic heating (ultrasonic cleaner, recommended frequency 20-40 kHz), vortexing, etc. to assist dissolution.
순도&문서
-
Data Sheet (276 KB)
-
SDS (252 KB)
- English - EN (252 KB)
- Français - FR (252 KB)
- Deutsch - DE (252 KB)
- Norwegian - NO (252 KB)
- Español - ES (252 KB)
- Swedish - SV (252 KB)
- Italian - IT (252 KB)
- Korean - KR (252 KB)
- Portuguese - PT (252 KB)
-
Handling Instructions (2659 KB)
References
Complete Stock Solution Preparation Table
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture and light). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
| Optional Solvent | Concentration Solvent Mass | 1 mg | 5 mg | 10 mg | 25 mg |
|---|---|---|---|---|---|
| DMSO | 1 mM | 2.2968 mL | 11.4840 mL | 22.9679 mL | 57.4198 mL |
| 5 mM | 0.4594 mL | 2.2968 mL | 4.5936 mL | 11.4840 mL | |
| 10 mM | 0.2297 mL | 1.1484 mL | 2.2968 mL | 5.7420 mL | |
| 15 mM | 0.1531 mL | 0.7656 mL | 1.5312 mL | 3.8280 mL | |
| 20 mM | 0.1148 mL | 0.5742 mL | 1.1484 mL | 2.8710 mL | |
| 25 mM | 0.0919 mL | 0.4594 mL | 0.9187 mL | 2.2968 mL | |
| 30 mM | 0.0766 mL | 0.3828 mL | 0.7656 mL | 1.9140 mL | |
| 40 mM | 0.0574 mL | 0.2871 mL | 0.5742 mL | 1.4355 mL | |
| 50 mM | 0.0459 mL | 0.2297 mL | 0.4594 mL | 1.1484 mL | |
| 60 mM | 0.0383 mL | 0.1914 mL | 0.3828 mL | 0.9570 mL | |
| 80 mM | 0.0287 mL | 0.1435 mL | 0.2871 mL | 0.7177 mL | |
| 100 mM | 0.0230 mL | 0.1148 mL | 0.2297 mL | 0.5742 mL |
Yoda2 Related Classifications
HY-175416 Related Classifications
Powered by Bioz