ETTAC-2
Based on 1 Customer Validation
ETTAC-2 is a LRG1 PROTAC degrader, degrading LRG1 via the ubiquitin-proteasome pathway with a DC50 value of 8.38 μM. ETTAC-2 penetrates damaged renal cells to reduce the extracellular secretion of LRG1. ETTAC-2 effectively inhibits the TGF-β-Smad3 signaling pathway and diminishes the secretion of fibrosis-associated extracellular matrix proteins. ETTAC-2 degrades LRG1 within fibrotic kidneys and the efficacy in inhibiting the TGF-β-Smad3 pathway both in vitro and vivo. ETTAC-2 can be used for renal fibrosis research.
商品は「研究用試薬」です。人や動物の医療用・臨床診断用・食品用の製品ではありません。
研究用途以外に使用した場合、当社は一切の責任を負いかねます。
- 純度: 99.94%
- 分子式: C83H123N23O26S
- 分子量:1891.07
-
保管条件:
Sealed storage, away from moisture.
Powder -80°C, 2 years , -20°C, 1 year* In solvent : -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture)
-
生物活性
-
化学情報
-
溶剤 & 溶解度
- 純度とドキュメンテーション
- 参考文献
-
Help & FAQs
PROTACs アイソフォーム固有の製品をすべて表示
More
生物活性
|
LRG1 8.38 μM (DC50) |
ETTAC-2 (0-26μM, 1-48 h) induces LRG1 degradation with an DC50 value of 8.38 μM in a time-dependent manner, which degradation can persist for 6 h in HK-2 cells via the ubiquitin-proteasome pathway[1].
ETTAC-2 alleviates cellular fibrosis in vitro by inhibiting the TGF- β-Smad3 pathway in HK-2 cells[1].
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Cell Line:HK-2 cells
-
Concentration:0, 1.625, 3.25, 6.5, 8.38, 13 and 26 μM
-
Incubation Time:0, 1, 3, 5, 8, 18 and 24 h
-
Result:Induced LRG1 degradation in a time-dependent manner.
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Animal Model:Male C57BL/6 mice (20 g) (reserved unilateral ureteral obstruction) [1]
-
Dosage:50 mg/kg
-
Administration:i.v., daily for five days
-
Result:Significant reduced BUN and SCR levels.
Displayed similar kidney appearances, with no notable differences.
Effectively reduced the weight increase of the obstructed kidney by 16.6%.
Markedly decreased renal tubular dilatation and vacuolization in tubular epithelial cells caused by UUO.
Revealed approximately a 50% reduction in renal pathological damage.
Revealed a 64.3% reduction in matrix deposition.
Decreased mRNA expression levels of α-SMA, collagen-1A1, and fibronectin by 79.4%, 74.2% and 58%, respectively.
Diminished the expression areas of α-SMA, collagen-1A1, and fibronectin by 64.4%, 73.4%, and 71.9% respectively.
Decreases in α-SMA, collagen-1A1, and fibronectin protein expression by 60.3%, 61.6% and 53.3%, respectively.
Led to a 46.9% decrease in LRG1 overexpressed.
Indicated a 62.9% reduction in LRG1 levels.
Led to a marked reduction in the fluorescent signals and a notable improvement in tubular structure.
Decreased phosphorylated Smad3 levels by 57.1%.
Had no significant impact on their body weight, did not induce notable morphological alterations in major organs (including heart, liver, spleen, and lungs).
化学情報
-
性状 Solid
-
分子量 1891.07
-
分子式 C83H123N23O26S
-
Color White to off-white
-
配列
Lenalidomide-(CC)-Gly-Gly-Glu-Ser-Tyr-Ser-Ala-Lys-His-Arg-Ile-Met-Leu-Thr
-
シーケンスの短縮
Lenalidomide-(CC)-GGESYSAKHRIMLT
-
輸送条件
Room temperature in continental US; may vary elsewhere.
-
保管条件
Sealed storage, away from moisture
Powder -80°C 2 years -20°C 1 year * In solvent : -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture)
溶剤 & 溶解度
DMSO : 100 mg/mL (52.88 mM; Need ultrasonic; Hygroscopic DMSO has a significant impact on the solubility of product, please use newly opened DMSO)
H2O : 2 mg/mL (1.06 mM; Need ultrasonic)
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
濃度 (開始) × 体積 (開始) = 濃度 (終了) × 体積 (終了)
Select the appropriate dissolution method based on your experimental animal and administration route.
- For the following dissolution methods, please ensure to first prepare a clear stock solution using an In Vitro approach and then sequentially add co-solvents:
- To ensure reliable experimental results, the clarified stock solution can be appropriately stored based on storage conditions. As for the working solution for In Vivo experiments, it is recommended to prepare freshly and use it on the same day.
- The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.
Add each solvent one by one: 10% DMSO 40% PEG300 5% Tween-80 45% Saline
Solubility: ≥ 2.5 mg/mL (1.32 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 400 μL PEG300, and mix evenly; then add 50 μL Tween-80 and mix evenly; then add 450 μL Saline to adjust the volume to 1 mL.
Preparation of Saline: Dissolve 0.9 g sodium chloride in ddH₂O and dilute to 100 mL to obtain a clear Saline solution.
Add each solvent one by one: 10% DMSO 90% (20% SBE-β-CD in Saline)
Solubility: ≥ 2.5 mg/mL (1.32 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 900 μL 20% SBE-β-CD in Saline, and mix evenly.
Preparation of 20% SBE-β-CD in Saline (4°C, storage for one week): 2 g SBE-β-CD powder is dissolved in 10 mL Saline, completely dissolve until clear.
Please enter the basic information of animal experiments:
-
-
-
-
Recommended: Prepare an additional quantity of animals to account for potential losses during experiments.
Please enter your animal formula composition:
-
%DMSO +
Recommended: Keep the proportion of DMSO in working solution below 2% if your animal is weak.
-
%+
-
+%Tween-80 + +
-
%Saline +
The co-solvents required include: DMSO, . All of co-solvents are available by MedChemExpress (MCE). , Tween 80. All of co-solvents are available by MedChemExpress (MCE).
Working solution concentration: 0.22 mg/mL
Method for preparing stock solution: mg drug dissolved in μL DMSO. Stock solution concentration: mg/mL. * In solvent : -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture)
1. Take μL DMSO stock solution;
2. Add μL .
μL , mix evenly;
3. Then add μL Tween 80, mix evenly;
4. Then add μL
Please ensure that the stock solution in the first step is dissolved to a clear state, and add co-solvents in sequence. You can use ultrasonic heating (ultrasonic cleaner, recommended frequency 20-40 kHz), vortexing, etc. to assist dissolution.
純度とドキュメンテーション
-
データシート (276 KB)
-
SDS (252 KB)
- English - EN (252 KB)
- Français - FR (252 KB)
- Deutsch - DE (252 KB)
- Norwegian - NO (252 KB)
- Español - ES (252 KB)
- Swedish - SV (252 KB)
- Italian - IT (252 KB)
- Portuguese - PT (252 KB)
-
取扱説明書 (2659 KB)
参考文献
Complete Stock Solution Preparation Table
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture). When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
| Optional Solvent | Concentration Solvent Mass | 1 mg | 5 mg | 10 mg | 25 mg |
|---|---|---|---|---|---|
| H2O / DMSO | 1 mM | 0.5288 mL | 2.6440 mL | 5.2880 mL | 13.2200 mL |
| DMSO | 5 mM | 0.1058 mL | 0.5288 mL | 1.0576 mL | 2.6440 mL |
| 10 mM | 0.0529 mL | 0.2644 mL | 0.5288 mL | 1.3220 mL | |
| 15 mM | 0.0353 mL | 0.1763 mL | 0.3525 mL | 0.8813 mL | |
| 20 mM | 0.0264 mL | 0.1322 mL | 0.2644 mL | 0.6610 mL | |
| 25 mM | 0.0212 mL | 0.1058 mL | 0.2115 mL | 0.5288 mL | |
| 30 mM | 0.0176 mL | 0.0881 mL | 0.1763 mL | 0.4407 mL | |
| 40 mM | 0.0132 mL | 0.0661 mL | 0.1322 mL | 0.3305 mL | |
| 50 mM | 0.0106 mL | 0.0529 mL | 0.1058 mL | 0.2644 mL |
* Note: If you choose water as the stock solution, please dilute it to the working solution, then filter and sterilize it with a 0.22 μm filter before use.
Powered by Bioz