FPFT-2216
Based on 1 Customer Validation
FPFT-2216, a “molecular glue” compound, degrades phosphodiesterase 6D (PDE6D), zinc finger transcription factors Ikaros (IKZF1), Aiolos (IKZF3), and casein kinase 1α (CK1α). FPFT-2216 can be used for the research of cancer and inflammatory disease.
Nos produits utilisent uniquement pour la recherche. Nous ne vendons pas aux patients.
- Pureté: 99.55%
- CAS No.: 2367619-87-0
- Formule: C12H12N4O3S
- Masse moléculaire:292.31
-
Stockage:Powder -20°C, 3 years , 4°C, 2 years ; In solvent -80°C, 6 months , -20°C, 1 month
To place orders, for customer services and technical support, please contact: MedChemExpress USA
Tel: 609-228-6898 E-mail: [email protected] [email protected]
-
Activité biologique
-
Chemical Information
-
Solvant et solubilité
- Pureté et documentation
- Références
-
Help & FAQs
-
Cell Cycle/DNA Damage Compound Library
HY-L004
-
Immunology/Inflammation Compound Library
HY-L007
-
Kinase Inhibitor Library
HY-L009
-
Metabolism/Protease Compound Library
HY-L012
-
Stem Cell Signaling Compound Library
HY-L017
-
Wnt/Hedgehog/Notch Compound Library
HY-L020
-
Anti-Cancer Compound Library
HY-L025
-
Anti-Aging Compound Library
HY-L034
-
Orally Active Compound Library
HY-L061
-
Anti-Alzheimer's Disease Compound Library
HY-L069
-
Neurodegenerative Disease-related Compound Library
HY-L086
-
Transcription Factor-Targeted Library
HY-L090
-
Anti-Colorectal Cancer Compound Library
HY-L103
-
Cancer Stem Cells Compound Library
HY-L135
-
Molecular Glue Compound Library
HY-L137
-
Heterocyclic Compound Library
HY-L138
-
Metabolic Enzyme Compound Library
HY-L146
-
Serine/Threonine Kinase Inhibitor Library
HY-L164
-
Multi-Target Compound Library
HY-L176
-
Bioactive Compound Library Max
HY-L181
-
MCE Bioactive Compound Library
HY-L001V
-
Bioactive Compound Library
HY-L001
-
Protein Kinase Compound Library
HY-L196
-
High-Throughput Bioactive Compound Library
HY-L205
-
Posttranslational Modification Library
HY-L226
-
3D Diverse Fragment Library
HY-L903
Activité biologique
|
PDE6D |
CK1α |
IKZF1 |
IKZF3 |
FPFT-2216 (1 μM; 5 hours) is able to degrade PDE6D, in addition to its known targets IKZF1, IKZF3, and CK1α in MOLT4 cells[1].
?
FPFT-2216 (1 μM; 0 h, 2 h, 4 h, 6 h, 16 h, 24 h) shows complete degradation of PDE6D within 2 h, and the degradation of PDE6D persists for at least 24 h in MOLT4 cells[1].
?
FPFT-2216 (0 nM, 1.6 nM, 8 nM, 40 nM, 200 nM, 1 μM; 4 h) exhibits over 50% degradation of PDE6D at a dose of 8 nM, while maximum degradation of PDE6D along with IKZF1, IKZF3, and CK1α at a dose of 200 nM in MOLT4 cells[1].
?
FPFT-2216 does not impede the growth of KRASG12C-dependent MIA PaCa-2 cells[1].
?
FPFT-2216 (10, 20, 40 μM; 14 or 24 h) highly up-regulates the production of IL-2 although it is less potent than that of Pomalidomide in Naive CD4+ T cells[2].
?
FPFT-2216 (10 μM; 14 or 24 h) degrades IKZF1 and CK-1α among ubiquitin–proteasomal degradative substrates of immunomodulatory drugs (IMiDs) in Naive CD4+ T cells[2].
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Cell Line:MOLT4 cells
-
Concentration:1 μM
-
Incubation Time:0 h, 2 h, 4 h, 6 h, 16 h, 24 h
-
Result:Showed complete degradation of PDE6D within 2 h, and the degradation of PDE6D persisted for at least 24 h.
-
Cell Line:MOLT4 cells
-
Concentration:0 nM, 1.6 nM, 8 nM, 40 nM, 200 nM, 1 μM
-
Incubation Time:4 h
-
Result:Exhibited over 50% degradation of PDE6D at a dose of 8 nM, while maximum degradation of PDE6D along with IKZF1, IKZF3, and CK1α at a dose of 200 nM.
MedChemExpress (MCE) has not independently confirmed the accuracy of these methods. They are for reference only.
-
Animal Model:CRBNI391V mice[2]
-
Dosage:30 mg/kg (solubilized in 0.5% carboxymethylcellulose/sodium and 0.25% Tween 80)
-
Administration:p.o. or i.p.
-
Result:Induced significant degradation of CK-1α, and IKZF1.
Chemical Information
-
CAS No. 2367619-87-0
-
Appearance Solid
-
Masse moléculaire 292.31
-
Formule C12H12N4O3S
-
Color Light yellow to light brown
-
SMILES
O=C(C(N1N=NC(C2=CSC=C2OC)=C1)CC3)NC3=O
-
Livraison
Room temperature in continental US; may vary elsewhere.
-
Stockage
Powder -20°C 3 years 4°C 2 years In solvent -80°C 6 months -20°C 1 month
Solvant et solubilité
DMSO : 100 mg/mL (342.10 mM; Need ultrasonic; Hygroscopic DMSO has a significant impact on the solubility of product, please use newly opened DMSO)
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month. When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month. When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
Concentration (start) × Volume (start) = Concentration (final) × Volume (final)
Select the appropriate dissolution method based on your experimental animal and administration route.
- For the following dissolution methods, please ensure to first prepare a clear stock solution using an In Vitro approach and then sequentially add co-solvents:
- To ensure reliable experimental results, the clarified stock solution can be appropriately stored based on storage conditions. As for the working solution for In Vivo experiments, it is recommended to prepare freshly and use it on the same day.
- The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.
Add each solvent one by one: 10% DMSO 40% PEG300 5% Tween-80 45% Saline
Solubility: ≥ 2.5 mg/mL (8.55 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 400 μL PEG300, and mix evenly; then add 50 μL Tween-80 and mix evenly; then add 450 μL Saline to adjust the volume to 1 mL.
Preparation of Saline: Dissolve 0.9 g sodium chloride in ddH₂O and dilute to 100 mL to obtain a clear Saline solution.
Add each solvent one by one: 10% DMSO 90% (20% SBE-β-CD in Saline)
Solubility: ≥ 2.5 mg/mL (8.55 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown).
Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 900 μL 20% SBE-β-CD in Saline, and mix evenly.
Preparation of 20% SBE-β-CD in Saline (4°C, storage for one week): 2 g SBE-β-CD powder is dissolved in 10 mL Saline, completely dissolve until clear.
Please enter the basic information of animal experiments:
-
-
-
-
Recommended: Prepare an additional quantity of animals to account for potential losses during experiments.
Please enter your animal formula composition:
-
%DMSO +
Recommended: Keep the proportion of DMSO in working solution below 2% if your animal is weak.
-
%+
-
+%Tween-80 + +
-
%Saline +
The co-solvents required include: DMSO, . All of co-solvents are available by MedChemExpress (MCE). , Tween 80. All of co-solvents are available by MedChemExpress (MCE).
Working solution concentration: 0.22 mg/mL
Method for preparing stock solution: mg drug dissolved in μL DMSO. Stock solution concentration: mg/mL.
1. Take μL DMSO stock solution;
2. Add μL .
μL , mix evenly;
3. Then add μL Tween 80, mix evenly;
4. Then add μL
Please ensure that the stock solution in the first step is dissolved to a clear state, and add co-solvents in sequence. You can use ultrasonic heating (ultrasonic cleaner, recommended frequency 20-40 kHz), vortexing, etc. to assist dissolution.
Pureté et documentation
-
Fiche technique (280 KB)
-
SDS (251 KB)
- English - EN (251 KB)
- Français - FR (251 KB)
- Deutsch - DE (251 KB)
- Norwegian - NO (251 KB)
- Español - ES (251 KB)
- Swedish - SV (251 KB)
- Italian - IT (251 KB)
- Korean - KR (251 KB)
- Portuguese - PT (251 KB)
-
Instruction de manipulation (2659 KB)
Références
[1]. Teng M, et al. Development of PDE6D and CK1α Degraders through Chemical Derivatization of FPFT-2216. J Med Chem. 2022 Jan 13;65(1):747-756. [Content Brief]
[2]. Gemechu Y, et al. Humanized cereblon mice revealed two distinct therapeutic pathways of immunomodulatory drugs. Proc Natl Acad Sci U S A. 2018;115(46):11802-11807. [Content Brief]
Complete Stock Solution Preparation Table
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles.
Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month. When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
| Optional Solvent | Concentration Solvent Mass | 1 mg | 5 mg | 10 mg | 25 mg |
|---|---|---|---|---|---|
| DMSO | 1 mM | 3.4210 mL | 17.1051 mL | 34.2103 mL | 85.5256 mL |
| 5 mM | 0.6842 mL | 3.4210 mL | 6.8421 mL | 17.1051 mL | |
| 10 mM | 0.3421 mL | 1.7105 mL | 3.4210 mL | 8.5526 mL | |
| 15 mM | 0.2281 mL | 1.1403 mL | 2.2807 mL | 5.7017 mL | |
| 20 mM | 0.1711 mL | 0.8553 mL | 1.7105 mL | 4.2763 mL | |
| 25 mM | 0.1368 mL | 0.6842 mL | 1.3684 mL | 3.4210 mL | |
| 30 mM | 0.1140 mL | 0.5702 mL | 1.1403 mL | 2.8509 mL | |
| 40 mM | 0.0855 mL | 0.4276 mL | 0.8553 mL | 2.1381 mL | |
| 50 mM | 0.0684 mL | 0.3421 mL | 0.6842 mL | 1.7105 mL | |
| 60 mM | 0.0570 mL | 0.2851 mL | 0.5702 mL | 1.4254 mL | |
| 80 mM | 0.0428 mL | 0.2138 mL | 0.4276 mL | 1.0691 mL | |
| 100 mM | 0.0342 mL | 0.1711 mL | 0.3421 mL | 0.8553 mL |
FPFT-2216 Related Classifications
HY-145319 Related Classifications
Powered by Bioz